General Trading Chat

ST Da,

In Asian Paints also, TD sequential buy 13 is completed on 13th Dec. A Long signal will be active above 13th candle high. is it right?




Regards,
Your set up and countdown markings are correct.

Use a standard qualifier that after countdown day 10 , for 11,12 and 13 we need lower closes,meaning close of CD bar 12 should be less than close of CD bar 11...and so on. This will avoid getting a buy signal at higher levels and it gives 13 th CD bar at the low and after 13, the day when we have close >open, that is a buy signal.

Smart_trade
 
Dada is there a way to track sequential other then using ami AFL?

Sent from my AO5510 using Tapatalk
There are many qualifiers in sequential .The AFL does not consider these and hence AFL can be used to plot the set ups...but countdowns and exact fine tuning with qualifiers is best done manually as there is no AFL incorporating all qualifiers.

ST
 
Is amibroker a must to use TD? can they be used on normal charts available in kite/zerodha?

thanks
Amibroker is not a must. You can work with sequential with any price chart.Set ups are identified visually and then put the TDST line and the markings on the chart.

I used to track sequential on Metastock with the help of a crude utility I had made earlier.....it is easy.

ST
 

wisp

Well-Known Member
There are many qualifiers in sequential .The AFL does not consider these and hence AFL can be used to plor the set ups...but countdowns and exact fine tuning with qualifiers is best done manually as there is no AFL incorporating all qualifiers.

ST
ST Da,
Is there a list of qualifiers somewhere in TJ? IF not would you please give them? Thanks a lot.
 
Amibroker is not a must. You can work with sequential with any price chart.Set ups are identified visually and then put the TDST line and the markings on the chart.

I used to track sequential on Metastock with the help of a crude utility I had made earlier.....it is easy.

ST
Sir, any book/reference material suggested by you on TD for beginers.

Thanks
 
Sir, any book/reference material suggested by you on TD for beginers.

Thanks
DeMark books are best for learning. But DeMark language is difficult...for beginners there is a book by Jasson Pal...it is in easy language and good enough for basics.It is available in PDF form on the internet.

ST
 

VJAY

Well-Known Member
_SECTION_BEGIN("TD Systems");
// Parameters
ShowNumbers= ParamToggle("Show 1-8 Numbers","No|Yes", 0);
ShowTDPoints = ParamToggle("Show TD Points", "No|Yes", 0);
ShowTDST = ParamToggle("Show TD Setup Trend", "No|Yes", 1);
tdstsa = 0;
tdstba = 0;
/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
//********************************************** TD Points********************************************************************/
function TD_Supply()
{
return ( H > Ref(H, 1) AND H > Ref(H, -1) AND H > Ref(C, -2));
}
function TD_Demand()
{
return ( L < Ref(L, 1) AND L < Ref(L, -1) AND L < Ref(C, -2));
}
/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
// *********************************************** TD Sequential************************************************************/
// *** Setup Buy Signal ***
//nine consecutive days closes less than the close four days earlier
Con = C < Ref( C, -4);
Buy9Bars = BarsSince(BarsSince(Con));
Buy9Signal = Buy9Bars == 9;

// *** Requirements ***
//The first day of the nine-day must be preceded by a close day immediately before it that is greater than OR equal to the Close four days earlier
Con = Ref(C, -9) >= Ref(C, -13);
Buy9Req = Buy9Signal AND Con;

// *** Intersection ***
// the high of either day 8 or day 9 is greater than or equal to the low three,four, five, six, OR seven days earlier
Con1 = (H >= Ref(L, -3)) OR ( Ref(H, -1) >= Ref(L, -3));
Con2 = (H >= Ref(L, -4)) OR ( Ref(H, -1) >= Ref(L, -4));
Con3 = (H >= Ref(L, -5)) OR ( Ref(H, -1) >= Ref(L, -5));
Con4 = (H >= Ref(L, -6)) OR ( Ref(H, -1) >= Ref(L, -6));
Con5 = (H >= Ref(L, -7)) OR ( Ref(H, -1) >= Ref(L, -7));

Buy9Intr = Buy9Req AND (Con1 OR Con2 OR Con3 OR Con4 OR Con5);
/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
// *** Setup Sell Signal ***
//nine consecutive days closes greater than the Close four days earlier.
Con = C > Ref( C, -4);
Sell9Bars = BarsSince(BarsSince(Con));
Sell9Signal = Sell9Bars == 9;

// *** Requirements ***
//The first day of the nine-day must be preceded by a Close day immediately before it that is less than the Close four days earlier
Con = Ref(C, -9) < Ref(C, -13);
Sell9Req = Sell9Signal AND Con;

// *** Intersection ***
//the low of either day 8 or day 9 is less than or equal to the high three,four, five, six, OR seven days earlier
Con1 = (L <= Ref(H, -3)) OR ( Ref(L, -1) <= Ref(H, -3));
Con2 = (L <= Ref(H, -4)) OR ( Ref(L, -1) <= Ref(H, -4));
Con3 = (L <= Ref(H, -5)) OR ( Ref(L, -1) <= Ref(H, -5));
Con4 = (L <= Ref(H, -6)) OR ( Ref(L, -1) <= Ref(H, -6));
Con5 = (L <= Ref(H, -7)) OR ( Ref(L, -1) <= Ref(H, -7));

Sell9Intr = Sell9Req AND (Con1 OR Con2 OR Con3 OR Con4 OR Con5);
/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
if(StrToNum(NumToStr(Buy9Intr))) Sell9Intr = False;
if(StrToNum(NumToStr(Sell9Intr))) Buy9Intr = False;
BuySignal = Flip(Buy9Intr, Sell9Intr);
/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
// *** Buy Countdown ***
//With respect to a pending Buy Signal, the close must be less than the low two days earlier
Con = C < Ref(L, -2);
Buy13Count = Sum(Con AND BuySignal, BarsSince(Buy9Intr));
Buy13Signal = Buy13Count == 13;

/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
// *** Sell Countdown ***
//with respect to a pending Sell Signal, the Close must be greater than the High two trading days earlier.
Con = C > Ref(H, -2);
Sell13Count = Sum(Con AND NOT BuySignal, BarsSince(Sell9Intr));
Sell13Signal = Sell13Count == 13;
/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
//*********************************************** TD Sequential Plotting area *************************************************/
Plot(C, "", IIf(O>=C, colorRed, colorGreen), styleBar);
PlotShapes(IIf(Buy9Intr OR Sell9Intr, shapeDigit9, shapeNone),colorBlue, 0, H,20);
if(ShowNumbers)
PlotShapes(IIf(Buy9Bars==1, shapeDigit1,
IIf(Buy9Bars==2, shapeDigit2,
IIf(Buy9Bars==3, shapeDigit3,
IIf(Buy9Bars==4, shapeDigit4,
IIf(Buy9Bars==5, shapeDigit5,
IIf(Buy9Bars==6, shapeDigit6,
IIf(Buy9Bars==7, shapeDigit7,
IIf(Buy9Bars==8, shapeDigit8,
IIf(Buy9Bars >9, shapeStar,shapeNone))))))))),colorGreen, 0, H, H*.015);
if(ShowNumbers)
PlotShapes(
IIf(Sell9Bars==1, shapeDigit1,
IIf(Sell9Bars==2, shapeDigit2,
IIf(Sell9Bars==3, shapeDigit3,
IIf(Sell9Bars==4, shapeDigit4,
IIf(Sell9Bars==5, shapeDigit5,
IIf(Sell9Bars==6, shapeDigit6,
IIf(Sell9Bars==7, shapeDigit7,
IIf(Sell9Bars==8, shapeDigit8,
IIf(sell9bars>9, shapeStar,shapeNone))))))))),colorRed, 0, H, H*.015);

Sell = Sell13Signal AND NOT BuySignal;
Buy = Buy13Signal AND BuySignal;
Sell = ExRem(Sell, Buy);
Buy = ExRem(Buy, Sell);
PlotShapes(Sell*shapeDownArrow, colorYellow, 0, H, -H*.001);
PlotShapes(Buy*shapeUpArrow, colorBrightGreen, 0, L, -L*.001);

if(StrToNum(NumToStr(BuySignal)))
bgColor = ColorRGB(0,66, 2);
else
bgColor = ColorRGB(66,2, 0);
/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
//*********************************************** TD Points Plotting area *************************************************/
if(ShowTDPoints)
{
PlotShapes(TD_Supply()*shapeSmallCircle, colorRed, 0, H, H*.001);
PlotShapes(TD_Demand()*shapeSmallCircle, colorGreen, 0, L, -L*.001);
///////////////////////////////////////////////////////////////////////////
y0 = StrToNum(NumToStr(ValueWhen(TD_Demand(), L)));
x = LineArray(0, y0, (BarCount-1), y0);
Plot(x, "", colorGold, styleDashed);
y0 = StrToNum(NumToStr(ValueWhen(TD_Supply(), H)));
x = LineArray(0, y0, (BarCount-1), y0);
Plot(x, "", colorGold, styleDashed);
}
/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
//*********************************************** TDST Plotting area *************************************************/
// ---------------->>>> Code from Dave <<<---------------------- //
if(ShowTDST)
{
tdstba =Cum(0);
tdstb = Null;
HHV9 = HHV(H,9);
for (i = 0; i < 10; i++) tdstba = Null;

for( i = 10; i < BarCount; i++ )
{
if (Buy9Bars == 9)
{
HHV_b = HHV9;
if (HHV_b > C[i-9])
tdstb = HHV_b;
else tdstb = C[i-9];

for (j = 0; j < 9; j++ )
tdstba[i-j] = tdstb;
}
else tdstba = tdstb;
}

tdstsa =Cum(0);
tdsts = Null;
LLV9 = LLV(L,9);
for (i = 0; i < 10; i++) tdstsa = Null;

for( i = 10; i < BarCount; i++ )
{
if (Sell9Bars == 9)
{
LLV_b = LLV9;
if (LLV_b < C[i-9])
tdsts = LLV_b;
else tdsts = C[i-9];

for (j = 0; j < 9; j++ )
tdstsa[i-j] = tdsts;
}
else tdstsa = tdsts;
}
Plot(tdstba, "TDSTb", colorBlue,styleStaircase | styleThick|styleDots);
Plot(tdstsa, "TDSTs", colorRed,styleStaircase | styleThick|styleDots);

}


hope this helps
 

Similar threads